Cybex Pro+ Treadmill Service Manual
Preventive
Maintenance
Page 2-7
Service Schedule
All maintenance activities shall be performed by qualifi ed personnel. Failure to do so could result in
serious injury.
NOTE: This is the minimum recommended service.
1. Determine mileage.
While in A. Dormant Mode enter Test Mode by holding down any key while turning the treadmill to
the on (I) position.
Press theB. DIST button to display “DIST” and miles or kilometers will be displayed.
Record Mileage.C.
NOTE: To exit Test Mode, press the Stop key .
First 500 miles (800 km).
Check running belt tension and tracking.•
Every 5,000 miles (8,000 km).
Check running belt tension and tracking.•
Move treadmill and vacuum underneath.•
Remove motor cover to clean underneath with a dry cloth and vacuum.•
Every 10,000 miles (16,090 km).
Replace running belt and fl ip deck.•
Check motor brushes and replace if needed.•
Check current draw.•
Measure motor voltage at max speed with no load.•
Check elevation assembly and replace worn parts.•
Lubricate elevation pivot points.•
Every 20,000 miles (32,180 km).
Replace running belt and deck.•
To Next Page
Loading...
Need help?
General
