Cybex Pro+ Treadmill Service Manual
Service
Page 4-2
! WARNING: All maintenance activities shall be performed by qualifi ed personnel.
Failure to do so could result in serious injury.
For any service related concerns, call Cybex
Customer Service at 888-462-9239 (for Cybex
customers living within the USA). For customers
living outside the USA, call 508-533-4300 or fax
508-533-5183.
NOTE: Read and understand each procedure
thoroughly before servicing. Unless
otherwise noted “right” and “left” denote
user orientation for all procedures.
Test Mode
To enter Test Mode press and hold down any key
on the display while turning the power switch to the
on (I) position. When all keys are released “PRO”
and the software revision “rx.x” are shown on the
display. To exit Test Mode press Stop.
Stuck Key List
If Test Mode occurs without holding any keys, a key may be stuck closed or Error 7 may have occurred.
You may need to replace the upper and/or lower display overlay. See Figure 1. If “KEY#” is displayed you
can determine which key is stuck closed by referring to the number list below.
Upper
Overlay
Lower
Overlay
Figure 1
1 Stop
2 Incline Down
3 Speed Down
4 Weight
5 Distance
7 Heart Rate
8 Manual Up
9 Incline
10 Speed Up
11 Quick Start
12 Center Up
13 9 Holes
14 Level
15 Mets
16 5K
17 Enter
18 Cardio
19 Center Down
20 Calories
21 HR Control
22 Time
23 Scan
24 Age
25 Min Mi/Km
26 Weight Loss
To Next Page
Loading...
Need help?
General
