CYBEX VR2 User Manual

Delivery
& Installation
Page 5-6
Cybex VR2 Owner’s Manual
5. Install weight plate decals.
NOTE:Place weight plate decals (weight in
pounds for standard units or if desired,
number of weight plates for International
units) on weight plates according to steps
listed below and Figures 11 and 12.
A. Slowly and carefully peel off back side of
decal. NOTE: When peeling off back cover,
make sure that the decals remain attached to
the front sticker.
B. Align holes in decal with appropriate holes in
weight stack. NOTE: Do not allow the
adhesive to touch weight stack at this time.
C. Insert a guide pin through each hole of the
template. NOTE: A guide pin can be any-
thing that fits through the weight stack hole,
such as a weight stack selector pin.
D. Carefully align decal and rub it onto weight
plates.
E. Carefully remove front side, leaving decals
adhering to weight plates.
Figure 11
Figure 12
Figure 10
D. Lift top weight and insert all three
increment weights onto the increment
weight rod (attached to the frame) then
carefully lower the top weight.
E. Verify increment weight rods are at the
same height by sliding the increment
weights from one increment weight rod to
the other.
SHCS
(adjustment for
height of incre-
ment weight rod)
SHCS
Guide Pin
Decal
Increment
Weight Rod

CYBEX VR2 Specifications

General

Category	Fitness Equipment
Frame Material	Steel
Weight Stack	Varies by model
Dimensions	Varies by model
Weight Capacity	Varies by model
Color Options	Varies by model
Warranty	Varies by model
Adjustability	Yes