D-Link DAP-3711

27D-Link DAP-3711 User Manual
Section 3 - Conguration
Advanced Settings
You can select the 802.11 mode which the DAP-
3711 should use. It is suggested to keep this setting
at 802.11ac to provide an optimal transmission
rate.
The DAP-3711 supports 2T2R Multi-Input-Multi-
Output. In high-interference environments, you
can set this to 1T1R to reduce the noise.
Enabling this function will automatically detect
the distance between the two DAP-3711 units
and optimize the link quality. Enabling this is
recommended. If you disable this function, you
will need to manually enter the distance between
the two units.
To use TDMA, you will need to enable TDMA
mode in both DAP-3711 units. TDMA can prevent
802.11 hidden node issues. When setting up PTMP,
enabling TDMA is recommended. The TDMA
function can only work between two DAP-3711
units.
When TDMA is enabled, you can also decide
whether you want to enable JTrans. JTrans can help
prevent an internal wireless attack. The client and
access point must be turned on at the same time
when JTrans is enabled.
802.11 Mode:
MIMO:
Auto ACK:
TDMA: