D-Link DAP-3711 - Page 28

28D-Link DAP-3711 User Manual
Section 3 - Conguration
Wireless Interface Settings
When you click Scan Signal, the device will
conduct a site survey to nd the SSIDs that the
DAP-3711 can detect. If you select an SSID, the
DAP-3711 will switch to client mode and connect
to the SSID you selected. Click the Edit button to
set up encryption (if required).
Scan Signal:
In this section, you can change the settings for the DAP-3711’s Wi-Fi
operation mode, SSID, encryption, and site survey.
Click this to perform a site survey again.
Click this to select which SSID the DAP-3711 should
connect to.
Use this to select which SSID and MAC address the
DAP-3711 should connect to. If you enable this, the
DAP-3711 will only connect to the AP you specify.
Click this to cancel the scan.
Rescan:
Select:
Lock:
Cancel: