D-Link DAP-X1870 User Manual
16
Section 3 - Conguration
Wireless Setup Wizard
To access the setup utility for the DAP-X1870 AX1800 Mesh Wi-Fi Extender on your
PC, first connect to the DAP-X1870 wirelessly using the
Wi-Fi name (SSID) and
password located on the back of your DAP-X1870. Then open a web browser and
enter http://dlinkap.local./ in your browser’s URL field. You may also enter the IP
address* of the DAP-X1870.
* The default IP address is 192.168.0.50. Once your DAP-X1870 connects to the host network,
it will be assigned a new IP address based on your network’s DHCP settings. You will need
to
log
in
to
your
router
to
see
what
IP
address
is
assigned
to
your
DAP-X1870.
For
multiple
DAP-X1870s, go to http://dlinkapxxxx.local.
as
shown on the included Quick
Installation
Card, with “xxxx” being the last four digits of the DAP-X1870’s MAC address.
If this is your rst time logging in to the extender and no connection has been
established, the setup wizard will automatically appear. If the setup process was
not previously completed, then log in to the interface by leaving the password
eld blank.
The setup wizard is designed to guide you through a step-by-step process to configure your new DAP-X1870
AX1800 Mesh Wi-Fi Extender to extend your wireless network and connect to the Internet via a wireless setup process. To set
your
DAP-X1870 using an Ethernet cable, please refer to
“Access Point Mode Settings”
on page 23.
To Next Page
Loading...
Need help?
General
