D-Link DCS-5010L

25D-Link DCS-5010L User Manual 25
Section 4 - Conguration
Conguration
Using the Web Conguration Utility
After completing the Camera Setup Wizard, you are ready to use your camera. The camera’s built-in Web conguration utility
is designed to allow you to easily access and congure your DCS-5010L. There are two ways in which you can access your
camera’s Web conguration interface:
• Log in to your mydlink account, click on the Settings tab, and click on Advanced Settings to access your camera’s Web
conguration utility.
• You can also access the interface locally by entering the IP address of your camera into a Web browser, such as Internet
Explorer. To log in, use the User name admin and the Password you created in the Setup Wizard. (If you did not create a
password, leave the password eld blank.) After entering your password, click OK.
Note: If you are directly connecting your camera to your PC, or if you are using the camera on a closed network, the default IP address
is 192.168.0.20. If the camera is connected to a router or network, a dierent IP address may have been assigned.
DCS-5010L