D-Link DCS-5010L

32D-Link DCS-5010L User Manual 32
Section 4 - Conguration
Wireless Setup
Check this box to allow your camera to connect to your network
wirelessly.
Enter the network name (SSID) of the wireless network you want to
connect to. You can also click the Site Survey button below to choose
an available network and ll in settings automatically.
If you are using Ad-Hoc as your connection mode, select the same
channel that is being used by your wireless network.
Select the connection mode used by your wireless network. In most
cases, you should select Infrastructure. Ad-Hoc is only used if your
camera is directly connecting to another PC or device without the use
of a router or access point.
Clicking this button will allow you to select an available wireless
network to connect to, and will ll in the necessary settings for you.
Select the wireless security mode used by your wireless network. If
you select WPA-PSK/WPA2-PSK, enter the password for your wireless
network in the text box that appears.
Click Save Settings.
Enable
Wireless:
SSID:
Channel:
Connection
Mode:
Site Survey:
Wireless
Security Mode:
This section allows you to set up and congure the wireless settings on your camera.