To Next Page

To Previous Page

LIVE VIDEO

This section allows you to set up your IP camera's live video by using the buttons below.

LIVE VIDEO > Camera

Audio – To receive voice from the area surrounding your DCS-950G, click this button to turn on the built-in microphone on your DCS-950G. The audio is on

by default.

Snapshot – Click it to capture a snapshot image. The image will pop up in a new window. Then you may save this image to a local hard drive.

Night Shot – Click this button if your IP camera is operating under low light condition. In this setting the DCS-950G will be able to view at 0.5 Lux.

Client Recording – Click this button will start recording video immediately to the file path specified in the right field.

Stop Client Recording – To stop recording video immediately, click this button.