3
Hardware Overview
Connections
Reset Button
Reset will be initiated when the reset
button is pressed once and Power LED
begins to flash.
Factory Reset will be initiated when the
reset button is pressed continuously for
ten seconds. Release the reset button
and the Power LED will begin to flash
indicating that the DCS-950G’s settings
are reverting back to the factory settings.
The IP address will also return to the
default setting of 192.168.0.20.
802.11g Antenna
The DCS-950G features an
802.11g wireless antenna for
802.11g wireless connectivity to
your existing wireless network.
The DCS-950G can be used in
conjunction with an 802.11g
compliant access point or router.
Ethernet Cable Connector
The DCS-950G features an RJ-45 connector
for connections to 10Base-T Ethernet cabling
or 100Base-TX Fast Ethernet cabling (which
should be Category 5 UTP cable). The port
supports the NWay protocol, allowing the
DCS-950G to automatically detect or
negotiate the transmission speed of the
network.
The port also supports MDI/X, which
allows the use of either straight through or
crossover cables.
DC Power Connector
The DC power input connector is labeled DC
5V with a single jack socket to supply power
to the DCS-950G.
To Next Page
Loading...
Need help?
General