D-Link DGS-3024 - Packets; Received (RX)

DGS-3024 Gigabit Ethernet Switch Manual
Figure 9- 5. Ping Test window
The user may use the Infinite times radio button, in the Repeat Pinging for field, which will tell the ping program to keep
sending ICMP Echo packets to the specified IP address until the program is stopped. The user may opt to choose a specific
number of times to ping the Target IP Address by clicking its radio button and entering a number between 1 and 255. Click
Start to initiate the Ping program.
Save Changes
The DGS-3204 has two levels of memory; normal RAM and non-volatile or NV-RAM. Configuration changes are made
effective by clicking the Apply button. When this is done, the settings will be immediately applied to the switching
software in RAM, and will immediately take effect.
Some settings, though, require you to restart the Switch before they will take effect. Restarting the Switch erases all settings
in RAM and reloads the stored settings from the NV-RAM. Thus, it is necessary to save all setting changes to NV-RAM
before rebooting the Switch.
To retain any configuration changes permanently, click the Save Changes link in the Maintenance folder. The following
window will appear:
Figure 9- 6. Save Configuration window
Click the Save Configuration button to save the current switch configuration in NV-RAM. The following dialog box will
confirm that the configuration has been saved:
103