DGS-3024 Gigabit Ethernet Switch Manual
Reauthenticate Port(s)
This window allows you to reauthenticate a port or group of ports by choosing a port or group of ports by using the pull
down menus From and To and clicking Apply. The Reauthenticate Port Table displays the current status of the
reauthenticated port(s) once you have clicked Apply.
Click Configuration > Port Access Entity > Reauthenticate Port(s) to open the Reauthenticate Port(s) window:
Figure 6- 47. Reauthenticate Port window
This window displays the following information:
Parameter Description
Port
The port number of the reauthenticated port.
MAC Address
Displays the physical address of the Switch where the port resides.
Auth State
The Authenticator State will display one of the following: Initialize, Disconnected,
Connecting, Authenticating, Authenticated, Aborting, Held, ForceAuth, ForceUnauth,
and N/A.
BackendState
The Backend State will display one of the following: Request, Response, Success, Fail,
Timeout, Idle, Initialize, and N/A.
OpenDir
Operational Controlled Directions are both and in.
PortStatus
The status of the controlled port can be Authorized, Unauthorized, or N/A.
64
To Next Page
Loading...
