DGS-3024 Gigabit Ethernet Switch Manual
Strict
The highest class of service is the first to process traffic. That is, the highest class of
service will finish before other queues empty.
RoundRobin
Use the weighted round-robin (WRR) algorithm to handle packets in an even
distribution in priority classes of service.
Click Apply to let your changes take effect.
NOTE: The settings you assign to the queues, numbers 0-7, represent the
IEEE 802.1p priority tag number. Do not confuse these settings with port
numbers.
Link Aggregation
Port trunk groups are used to combine a number of ports together to make a single high-bandwidth data pipeline.
The DGS-3024 supports up to four port trunk groups with 2 to 8 ports in each group. A potential bit rate of 8000 Mbps can
be achieved.
Figure 6- 29. Example of Port Trunk Group
The Switch treats all ports in a trunk group as a single port. Data transmitted to a specific host (destination address) will
always be transmitted over the same port in a trunk group. This allows packets in a data stream to arrive in the same order
they were sent.
NOTE: If any ports within the trunk group become disconnected, packets
intended for the disconnected port will be load shared among the other
uplinked ports of the link aggregation group.
48
To Next Page
Loading...
