DGS-3024 Gigabit Ethernet Switch Manual
Switch to Hub or Switch
These connections can be accomplished in a number of ways using a normal cable.
• A 10BASE-T hub or switch can be connected to the switch via a two-pair Category 3, 4, 5, or 5e UTP/STP cable.
• A 100BASE-TX hub or switch can be connected to the switch via a two-pair Category 5 or 5e UTP/STP cable.
• A 1000BASE-T switch can be connected to the switch via four-pair straight Category 5 or 5e UTP/STP cable.
Figure 4- 2. Switch connected to a normal (non-Uplink) port on a hub or switch using a straight or
crossover cable
Switch to Core Router Switch
This connection can be accomplished using the following fiber optic media:
• SFP Transceiver for 1000BASE-LX Single-mode fiber module (10km)
• SFP Transceiver for 1000BASE-SX Multi-mode fiber module (550m)
• SFP Transceiver for 1000BASE-LHX Single-mode fiber module (40km)
• SFP Transceiver for 1000BASE-ZX Single-mode fiber module (80km)
10
To Next Page
Loading...
