DGS-3024 Gigabit Ethernet Switch Manual
Figure 6- 31. Port Trunking Configuration window
The user-changeable parameters are as follows:
Parameter Description
Group ID [1-4]
Select an ID number for the group, between 1 and 4.
State
Trunk groups can be toggled between Enabled and Disabled. This is used to turn a
port trunking group on or off. This is useful for diagnostics, to quickly isolate a
bandwidth intensive network device or to have an absolute backup aggregation
group that is not under automatic control.
Type
The type of port trunking supported by the DGS-3024 is Static.
Master Port
Choose the Master Port for the trunk group using the pull-down menu.
Port Map
Choose the members of a trunked group. Up to eight ports per group can be
assigned to a group.
Active Port
Shows the port that is currently forwarding packets.
After setting the previous parameters, click Apply to allow your changes to be implemented. Successfully created trunk
groups will be show in the Current Trunking Group Entries table.
MAC Notification
MAC Notification is used to monitor MAC addresses learned and entered into the forwarding database.
Global Settings
To globally set MAC notification on the Switch, open the following window by opening the MAC Notification folder and
clicking the Global Settings link:
50
To Next Page
Loading...
