DGS-3024 Gigabit Ethernet Switch Manual
Advanced Settings
Figure 6- 3. Switch Information (Advanced Settings) window
The following fields can be set:
Parameter Description
Serial Port Auto
Logout
This setting for the restart of the console is 2 Minutes, 5 Minutes, 10 Minutes, 15
Minutes, or Never. The default is 10 Minutes.
Serial Port Baud
Rate
Determines the serial port bit rate that will be used the next time the switch is restarted.
Available speeds are 9600, 19,200, 38,400, and 115,200 bits per second. The default
setting is 9600.
MAC Address Aging
Time (0-14400 min)
This field specifies the length of time a learned MAC Address will remain in the
forwarding table without being accessed (that is, how long a learned MAC Address is
allowed to remain idle). To change this, type in a different value representing the MAC
address age-out time in seconds. The MAC Address Aging Time can be set to any
value between 0 and 14,400 min. The default setting is 5 min.
IGMP Snooping
This indicates if Internet Group Management Protocol (IGMP) Snooping is enabled on
the switch. When enabled, this feature instructs the switch to read IGMP packets being
forwarded through the switch in order to obtain forwarding information from them (learn
which ports contain Multicast members). The switch’s IGMP snooping state can be
changed on the IGMP Snooping Settings window (Configuration → IGMP → IGMP
Snooping).
Telnet Status
This indicates if a Telnet connection is currently enabled on the switch.
Web Status
Web-based management is Enabled by default. If you choose to disable this by select-
ing Disabled, you will lose the ability to configure the system through the web interface
as soon as these settings are applied
RMON Status
This indicates if RMON is enabled on the switch.
17
To Next Page
Loading...
