DGS-3024 Gigabit Ethernet Switch Manual
SNMP Host Table
Use the SNMP Host Table window to set up SNMP trap recipients.
Open the SNMP Manager folder, located in the Security Management folder and click on the SNMP Host Table link.
This will open the SNMP Host Table window, as shown below.
To delete an existing SNMP Host Table entry, click the corresponding
under the Delete heading.
To display the current settings for an existing SNMP Group Table entry, click the blue link for the entry under the Host IP
Address heading.
Figure 7- 13. SNMP Host Table window
To add a new entry to the Switch's SNMP Host Table, click the Add button in the upper left-hand corner of the window.
This will open the SNMP Host Table Configuration window, as shown below.
Figure 7- 14. SNMP Host Table Configuration window
The following parameters can set:
Parameter Description
Host IP Address
Type the IP address of the remote management station that will serve as the SNMP
host for the Switch.
SNMP Version
V1 - To specifies that SNMP version 1 will be used.
V2 - To specify that SNMP version 2 will be used.
V3-NoAuth-NoPriv - To specify that the SNMP version 3 will be used, with a
NoAuth-NoPriv security level.
V3-Auth-NoPriv - To specify that the SNMP version 3 will be used, with a Auth-
NoPriv security level.
V3-Auth-Priv - To specify that the SNMP version 3 will be used, with a Auth-Priv
security level.
76
To Next Page
Loading...
