Gigabit Ethernet Switch User’s Guide
95
Use this window to enable or disable the ingress filtering check for each desired port. Ingress filtering means
that a receiving port will check to see if it is a member of the VLAN ID in the packet before forwarding the
packet. Click
Apply
to let the settings take effect.
802.1Q VLAN Setup
Figure 7-33. Configure 802.1Q VLAN window
Click the pointer icon to access the Configure
802.1Q VLAN Entry
window:
Figure 7-34. Configure 802.1Q VLAN Entry window
To configure an 802.1Q VLAN entry, enter a VLAN ID number and VLAN Name in the first two fields. Next,
check Untag for each member port that is not a tagging port. None should be checked if you don’t want a port
to belong to a VLAN. Check Egress to statically set a port to belong to a VLAN. Checking Forbidden prevents
the port from joining a VLAN dynamically as well as defining the port as a non-member. Click
Apply
to let
the changes take effect.
To Next Page
Loading...
