Gigabit Ethernet Switch User’s Guide
69
To view this record, choose
Network Monitoring
from the main menu, and then choose
Switch History
from the
Network Monitoring
menu. A screen similar to that shown below will appear:
Figure 6-60. Switch History screen
The Switch can be commanded to upload its history via TFTP to a machine you specify. See
System Utilities
earlier in this chapter.
Resetting the Switch
You can use the console interface to reset the Switch, either doing a Restart System (which restarts the
Switch and is identical to powering the Switch off and back on again) or a Factory Reset to Default Value
(which sets all of the Switch’s parameters to what they were when the Switch was delivered from the factory).
Restart System
To perform a system reset, choose
Restart System
from the main menu. The following screen will appear:
Figure 6-61. Restart System screen
To Next Page
Loading...
