Gigabit Ethernet Switch User’s Guide
55
Figure 6-41. GMRP Configuration menu
The Switch GMRP field allows you to either enable or disable GMRP on the Switch by toggling between the
two choices and then pressing APPLY to let the change take effect.
Once GMRP is enabled for the Switch, you then must enable specific ports by selecting
Configure Port
GMRP Settings
from the
GMRP Configuration
menu above. The
GMRP Configuration
screen appears:
Figure 6-42. GMRP Configuration screen
Use this screen to enable or disable GMRP on individual ports. Press APPLY to let your changes take effect.
Configure Trunk
Ports on the switch can be grouped together in a single logical port called a trunk. This is discussed in detail
in the
Port Trunking
section of the chapter of this manual entitled
“Switch Management
Concepts.”
To set up
a trunk group, choose
Configure Trunk
from the
System Configuration
menu. The following screen
appears:
To Next Page
Loading...
