D-Link DGS-3208F - 4 Connecting the Switch; Pc to Switch; Switch ( Other Devices )

Gigabit Ethernet Switch User’s Guide
10
4
4 C
ONNECTING
T
HE
S
WITCH
This chapter describes how to connect the DGS-3208F to your Gigabit Ethernet network.
PC to Switch
A PC can be connected to the Switch via a fiber optic cable. The PC should be connected to any of the eight
ports (1x – 8x) of the DGS-3208F.
Figure 4-1. DGS-3208F Switch connected to a PC or Workstation (full-duplex mode is required)
The LED indicators for PC connection are dependent on the LAN card capabilities. If LED indicators are not
illuminated after making a proper connection, check the PC’s LAN card, the cable, Switch conditions, and
connections.
The following is an LED indicator possibility for a PC to Switch connection:
♦
The Link/ACT LED indicator lights up upon hookup.
Switch to Switch (other devices)
The Switch can be connected to another switch or other devices (routers, bridges, etc.) via a fiber optic cable.