DGS-3630 Series Layer 3 Stackable Managed Switch Hardware Installation Guide
13
Figure 2-4 Side panels of the DGS-3630-28TC
DGS-3630-28SC Switch
Front Panel Components
The front panel of DGS-3630-28SC features a variety of LED indicators and ports.
Figure 2-5 Front panel view of the DGS-3630-28SC
Ports that can be found on the front panel of this switch are listed in the table below.
The RJ45 (8 pins) Alarm port provides an external alarm detection. The Switch will
send out the traps and logs when two of the pins are shorted among the pair.
Inserting a flash drive into the USB 2.0 Type-A port provides an additional storage
space for portable firmware images and configuration files that can be copied to
and from the NVRAM of the Switch.
The RJ45 MGMT port is an IP-based, OOB port for Telnet, web, or SNMP
management that operates at 10/100/1000 Mbps wire-speed. This port can be
used to configure the Switch without being connected to the network.
The RJ45 console port can be used to connect to the CLI of the Switch for
configuration, management, and monitoring. This port uses a special console
cable (included in this package) with a DB9 interface to connect the Switch to the
serial port (COM) of the PC.
The Mini-USB console port can be used to connect to the CLI of the Switch for
configuration, management, and monitoring.
The Switch is equipped with 20 SFP ports. These ports can operate at 100 Mbps
and 1 Gbps wire-speeds.
The Switch is equipped with 4 combo ports that can either operate as RJ45 Ethernet
ports or SFP ports. The RJ45 ports can operate at 10 Mbps, 100 Mbps, and 1
Gbps wire-speeds. The SFP ports can operate at 100 Mbps and 1 Gbps wire-
speeds and support a wide collection of SFP transceivers.
The Switch is equipped with 4 SFP/SFP+ ports. These ports can operate at 1
Gbps and 10 Gbps wire-speeds and support a wide collection of SFP/SFP+
transceivers.
To Next Page
Loading...
