DGS-3630 Series Layer 3 Stackable Managed Switch Hardware Installation Guide
52
Appendix A - Technical Specifications
General
Stacking Topology: Duplex Ring, Duplex Chain
Stacking Bandwidth: Up to 80 Gbps
Stacking Ports: Up to 9 switches can be stacked using the 10 Gbps
SFP+ ports
Backup Master Support: Yes
UTP/STP Category 3, 4, 5 for 10BASE-T
UTP/STP Category.5, 5e for 100BASE-TX
UTP/STP Category 5e for 1000BASE-T
UTP/STP Category 6a for 10GBASE-T
EIA/TIA-568 100-ohm screened twisted-pair (STP) (100 m)
Physical and Environmental
DGS-3630-28TC: 100~240 VAC, 50~60 Hz, 2 A
DGS-3630-28SC: 100~240 VAC, 50~60 Hz, 2 A
DGS-3630-28PC: 100~240 VAC, 50~60 Hz, 6 A
DGS-3630-52TC: 100~240 VAC, 50~60 Hz, 2 A
DGS-3630-52PC: 100~240 VAC, 50~60 Hz, 6 A
Optional Redundant Power Supply
One connector in back to install optional external RPS. When internal
power fails, the optional external RPS will take over all the power supply
immediately and automatically.
DGS-3630-28TC: Supports DPS-500 and DPS-800
DGS-3630-28SC: Supports DPS-500 and DPS-800
DGS-3630-28PC: Supports DPS-700
DGS-3630-52TC: Supports DPS-500 and DPS-800
DGS-3630-52PC: Supports DPS-700
Provides a Kensington-compatible security lock, on the rear panel of the
Switch, to be able to connect to a secure immovable device. Insert the
lock into the notch and turn the key to secure the lock. The lock-and-
cable apparatus should be purchased separately
Be able to maintain the time setting when the device power is off
The IC Sensor detects the temperature on the switch automatically and
adjusts the speed
Supports a USB 2.0 Type-A flash drive with a maximum current of 1 A.
This slot only supports FAT16 and FAT32 file system architectures
To Next Page
Loading...
