DGS-3630 Series Layer 3 Stackable Managed Switch Hardware Installation Guide
42
Connect the male DB9 connector on the console cable (shipped with the Switch) to the RS-232 serial port on
the computer running terminal emulation software then insert the RJ45 connector into the RJ45 console port
on the front of the Switch.
To configure the terminal emulation software as follows:
Select the appropriate serial port (COM1 or COM2).
Set the data rate to 115200 baud.
Set the data format to 8 data bits, 1 stop bit, and no parity.
Set flow control to none.
Figure 5-1 COM Port Configuration
To be able to view the boot procedure, the Switch needs to be rebooted. The simplest way, at this stage, to reboot the
Switch is to unplug and re-insert the power cable from and into the power receptacle on the back of the Switch.
After correctly configuring the terminal settings and re-inserting the power cable, the boot procedure will appear in the
terminal.
Boot Procedure V2.25.002
-------------------------------------------------------------------------------
Power On Self Test ........................................ 100 %
MAC Address : F0-7D-68-30-36-00
H/W Version : A1
Please Wait, Loading 2.25.018 Runtime Image ............... 100 %
UART init .................................................. 100 %
Starting runtime image
Device Discovery ........................................... 100 %
Configuration init ......................................... 100 %
After the boot sequence has been completed, the console login screen will be displayed.
To Next Page
Loading...
