DIR-806A Wireless AC750 Multi-Function Router
User Manual
Configuring Device (Router Mode)
Client
On the Wi-Fi / Client page in the router mode, you can configure the device as a client to connect
to a WISP access point.
The “client” function in the router mode allows using DIR-806A as a WISP repeater.
To use the router as a WISP repeater, you need to configure the same channel of the wireless
connection for DIR-806A and the WISP access point. Other parameters of the wireless network of
DIR-806A do not depend upon the settings of the WISP access point.
Figure 101. Connecting DIR-806A in the router mode as a client.
After configuring the device as a client, you need to create a WAN connection with relevant
parameters for the WiFiClient port.
Page 138 of 233
To Next Page
Loading...
