DIR-806A Wireless AC750 Multi-Function Router
User Manual
Configuring Device (Router Mode)
Remote Access
On the Advanced / Remote access page, you can configure access to the web-based interface
of the router. By default, the access from external networks to the router is closed. If you need to
allow access to the router from the external network, create relevant rules.
Figure 109. The Advanced / Remote access page.
To create a new rule, click the Add button. In the line displayed, you can specify the following
parameters:
Parameter Description
IP address
A host or a subnet to which the rule is applied.
Mask The mask of the subnet.
Public port
An external port of the router. You can specify only one port.
Protocol The protocol available for remote management of the router.
After specifying the needed parameters, click the Apply button.
To edit a rule for remote access, select a needed field in the relevant line of the table, change its
value, and click the Apply button.
To remove a rule for remote access, select the checkbox located to the left of the relevant line in the
table and click the Apply button.
Page 151 of 233
To Next Page
Loading...
