DIR-806A Wireless AC750 Multi-Function Router
User Manual
Configuring Device (Access Point Mode)
Net
In this menu you can configure basic parameters of the local area network of the router.
LAN
To configure the router's local interface, proceed to the Net / LAN page.
Figure 139. Basic settings of the local interface.
If needed, edit the basic settings of the local interface.
Parameter Description
IP Address
The IP address of the router in the local subnet. By default, the
following value is specified: 192.168.0.1.
Netmask
The mask of the local subnet. By default, the following value is
specified: 255.255.255.0.
Gateway IP address
The gateway IP address for clients of the router. When this field is
left blank, clients use the IP address of the router as the gateway
address.
When needed settings are configured, click the Apply button.
In the DHCP server section, you can configure the built-in DHCP server of the router. In the
access point mode, the DHCP server is disabled by default.
Figure 140. The section for configuring the DHCP server.
Page 190 of 233
To Next Page
Loading...
