D-Link DPR-1260 - RangeBooster G Multifunction Print Server User Manual

35D-Link DPR-1260 User Manual
Section 4 - Security
Configure WPA-PSK
It is recommended to enable encryption on your wireless router before your wireless print server. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to
the added overhead.
1. Log into the web-based configuration by opening a
web browser and entering the IP address of the router
(192.168.0.1). Click on Wireless Settings on the left
side.
2. Next to Security Mode, select Enable WPA-Personal
Security or Enable WPA2-Personal Security.
3. Next to Cipher Mode, select TKIP, AES, or Auto.
4. Next to PSK/EAP, select PSK.
5. Next to Passphrase, enter a key (passphrase). The key is an
alpha-numeric password between 8 and 63 characters
long. The password can include symbols (!?*&_) and
spaces. Make sure you enter this key exactly the same on all other wireless clients.
6. Enter the passphrase again next to Confirmed Passphrase.
7. Click Save Settings to save your settings. If you are configuring the router with a wireless adapter, you will lose
connectivity until you enable WPA-PSK (or WPA2-PSK) on your adapter and enter the same passphrase as you did
on the router.

D-Link DPR-1260 - RangeBooster G Multifunction Print Server Specifications

General

Brand	D-Link
Model	DPR-1260 - RangeBooster G Multifunction Print Server
Category	Print Server
Language	English