D-Link DPR-1260 - RangeBooster G Multifunction Print Server User Manual

44D-Link DPR-1260 User Manual
Appendix B - Networking Basics
Appendix B - Networking Basics
Check your IP address
By default, the TCP/IP settings should be set to obtain an IP address from a DHCP server (i.e. wireless router)
automatically. To verify your IP address, please follow the steps below.
Click on Start > Run. In the run box type cmd and click OK.
At the prompt, type ipconfig and press Enter.
This will display the IP address, subnet mask, and
the default gateway of your adapter.
If the address is 0.0.0.0, check your adapter
installation, security settings, and the settings
on your router. Some firewall software programs
may block a DHCP request on newly installed
adapters.
If you are connecting to a wireless network at a hotspot (e.g. hotel, coffee shop, airport), please contact an employee
or administrator to verify their wireless network settings.

D-Link DPR-1260 - RangeBooster G Multifunction Print Server Specifications

General

Brand	D-Link
Model	DPR-1260 - RangeBooster G Multifunction Print Server
Category	Print Server
Language	English