D-Link DSL-X3052E - Internet - Ethernet

34D-Link DSL-X3052E User Manual
Section 4 - Conguration
Internet - Ethernet
Your DSL-X3052E is equipped with a multi-purpose Gigabit Ethernet WAN port which can
be used to connect to the Internet. This port can also be used to connect to other Ethernet
based networks. In order for your DSL-X3052E to use Ethernet, you must congure the WAN
Connection Type and related WAN settings.
Congure your
WAN connection:
Select Ethernet to congure Ethernet connection settings.
Service Number: Select a service number from the drop-down menu to use or modify a
previously congured interface. To create a new service number for your
Ethernet connection, click Add. The service number corresponds to the
congured interface prole from your Ethernet WAN Connection Type.
VLAN Settings
Enable Vlan ID: Enable or disable VLAN settings.
Vlan ID: Enter the VLAN ID. Enter a value from 1 - 4094.
IPv4 Settings
Connection: Select the connection method for your Internet and refer to the
respective conguration page for setup information.
For Dynamic IP (DHCP) Address, refer to Connection Type:
Dynamic IP (DHCP) on page 35.
For Static IP Address, refer to Connection Type: Static IP on
page 37.
For PPPoE, refer to Connection Type: PPPoE on page 39.
For Bridge Mode, refer to Connection Type: Bridge Mode
on page 41.