D-Link DVG-7111S

DVG-7111S User’s Manual ADVANCED
D-Link Systems, Inc. 61
SIP CallerId Obtaining: Select the part of the SIP packet from the VoIP TA to obtain Caller ID. There
are several places where the Caller ID is located.
Remote-Party-Id Display Name - It is located at SIP → Remote-Party-ID → Before [<sip:]
Remote-Party-Id User Name - It is located at SIP → Remote-Party-ID → After [<sip:], Before
[@]
From-Header Display Name - The standard way is in SIP → Message Header → From → SIP
Display info.
From-Header User Name - It is locate at SIP -> Message Header -> From -> SIP from address
before [@].
Put Caller ID In URI: This feature is to put Caller ID in URL. The Caller ID is located in SIP →
Message Header → After [From:], Before [<sip:] by default settings. It will be located in SIP →
Message Header → After [<sip:], Before [@]if ticked.
INVITE With Remote-Party-ID Header: Check the box to comprise the information of Remote-Party-ID
in the message header of INVITE. Different format of INVITE header might cause the call not to be
connected. Please consult with your VoIP Service Provider before enabling it.
Callee Quick Media: DVG-7111S will send RTP to remote party immediately as user answer an
inbound call.
Support URI Percent-Encoding(RFC 3986): Check the box to encode/decode the letters of the basic
Latin alphabet, digits, and a few special characters which follow RFC 3986.
Compare SIP 'To' Header for Transit Out: Check the box to use the number of “To” to dial ou when
the calls are from VoIP to FXO and the number of Request line and “To” is different. Please consult your
VoIP Service Provider about the format of invite packet from Proxy.
Call Hold Compatible With RFC 2543: Check the box to comprise c=0.0.0.0 in SDP message to be
compatible with RFC2543.