Section 5 – Charging Your Device and Battery Management
D-Link DWR-2101 User Manual
Battery Management
-2101 is equipped with a rechargeable battery. Use the Type-C USB cable
to recharge it, or use it to plug the dev
ice into a power source.
battery, turn the device off, then remove the battery cover on the
back of the device by gently prying it up from the case using the corner notch. Then
unlock the white latch by sliding the latch switch up. Use the gap next to the
battery latch switch as leverage to gently pull the battery
out of its compartment.
Remember to slide the latch switch down to lock the battery back in place before
replacing the battery cover.
Note: Charge the battery only with a Type-C USB cable (included in the packaging) and a Type-C 5 V / 2 A adapter (not included in the packaging). Improper
charging methods of the device and the use of an incompatible charger may cause damage to your device and void its warranty.
To Next Page
Loading...
