D-Link DWR-2101 - Enabling WPS

Section 7 – Settings
D-Link DWR-2101 User Manual
17
Enabling WPS
Press the power button to wake up your screen.
Slide your finger across the indicator to unlock your screen. If you've set a password to unlock your device, you'll need to enter it to proceed.
Swipe your display to navigate to Settings on your homescreen.
Tap Settings.
Tap WPS.
Tap WPS Enable to enable WPS.
Tap WPS connect.
Select WPS or WPS PIN to connect to your device.
a. WPS - Press the WPS button on the Wi-Fi device within 120 seconds.
b. WPS PIN - Enter the WPS PIN (either a 4 digit or an 8 digit number), then tap . Then press the WPS button on the Wi-Fi device within 120
seconds.