D-Link DWR-2101 - Networking Basics; Check your IP address

Section 36 – Networking Basics
D-Link DWR-2101 User Manual
66
Networking Basics
Check your IP address
After you install your new D-Link adapter, by default, the TCP/IP settings should be set to obtain an IP address from a DHCP server (i.e. wireless
router) automatically. To verify your IP address, please follow the steps below.
Click on
Start > Run. In the run box type cmd and click OK.
(Windows® Vista™ users type cmd in the Start Search box.)
At the prompt, type
ipconfig and press Enter.
This will display the IP address, subnet mask, and the default
gateway of your adapter.
If the address is 0.0.0.0, check your adapter installation, security settings, and the settings on your router. Some firewall software programs may
block a DHCP request on newly installed adapters.