167
9
Configuring the Captive Portal
The Captive Portal (CP) feature allows you to block wired and wireless clients from accessing
the network until user verification has been established.
This chapter contains the following sections to help you configure and monitor the CP feature
on the Unified Switch.
• Configuring Global Captive Portal Settings
• Configuring the Captive Portal
• Monitoring and Configuring Captive Portal Users
• Associating Interfaces with the Captive Portal
• Viewing the Captive Portal Global Status
• Viewing the Client Summary
• SNMP Trap Configuration
For information about the commands you use to manage and maintain the APs by using the
CLI, see the D-Link CLI Command Reference.
NOTE:The captive portal configuration pages are available from the Security folder
under both the LAN and WLAN tabs.
Figure 75. Navigating to the Captive Portal Feature
To Next Page
Loading...
