170 © 2001- 2008 D-Link Corporation. All Rights Reserved.
D-Link Unified Access System User Manual
Changing the Captive Portal Settings
By default, the D-Link Unified Switch has one captive portal. You can change the settings for
that captive portal, and you can also create and configure up to nine additional portals. After
you create a captive portal from the CP Summary page, you can change its settings.
Figure 78. Captive Portal Configuration
Table 58 describes the fields on the CP Configuration page.
Protocol Indicates whether the portal uses HTTP or HTTPS.
Verification Specifies which type of user verification to perform:
• Guest: The user does not need to be authenticated by a database.
• Local: The switch uses a local database to authenticate users.
• RADIUS: The switch uses a database on a remote RADIUS server to
authenticate users.
To configure authorized users on the local or remote RADIUS database, see
“Monitoring and Configuring Captive Portal Users” on page 174.
Table 58. CP Configuration
Field Description
Enable Captive
Portal
Select the check box to enable the CP. Clear the check box to disable it.
Configuration
Name
This field allows you to change the name of the portal added from the CP
Summary page.
Table 57. Captive Portal Summary
Field Description
To Next Page
Loading...
Need help?
General
