208 © 2001- 2008 D-Link Corporation. All Rights Reserved.
D-Link Unified Access System User Manual
When you do not require authentication between the APs and the RADIUS server, the switch
uses the password “NOPASSWORD” in communications between the RADIUS client on the
switch and the RADIUS server. The RADIUS client on the switch uses this password when it
retrieves entries from the server. When you do require AP authentication, the password for AP
authentication to the Unified Switch (separate from and in addition to AP authentication to the
network) will be in this field.
Vendor-Specific (26)
Mode
Indicates whether this AP is
managed by the switch, by an
administrator, or is a rogue
AP.
WS Managed (1)
Standalone (2)
Acknowledged Rogue
(3)
Required
Vendor-Specific (26)
Profile-ID
If AP is managed by a switch,
the ID of the configuration
profile for this AP.
1-16 Required if
mode is WS
managed.
Vendor-Specific (26)
Switch-IP
If there is more than one WS
using this RADIUS server,
indicates the IP address of the
WS to managed this AP.
Valid IP Address Optional
Vendor-Specific (26)
Radio-1-Chan
Vendor-Specific (26)
Radio-2-Chan
Indicates a fixed channel for
the radio.
Valid channels depend
on the regulatory
domain (country-code)
and the configured
mode for that radio in
the assigned AP profile.
If the channel is not
valid, its ignored.
0 indicates automatic
channel assignment.
Optional, if
defined and
valid will
override auto
channel
configuration
Vendor-Specific (26)
Radio-1-Power
Indicates a fixed power
setting for the radio.
0, 1-100 percent
0 indicates automatic
power assignment.
Optional, if
defined and
valid will
override auto
power
configuration
Vendor-Specific (26)
Radio-2-Power
Indicates a fixed power
setting for the radio.
0, 1-100 percent
0 indicates automatic
power assignment.
Optional, if
defined and
valid will
override auto
power
configuration
Table 80. RADIUS Attributes for the Access Point
RADIUS Server
Attribute
Description Range Usage
To Next Page
Loading...
Need help?
General
