222 © 2001- 2008 D-Link Corporation. All Rights Reserved.
D-Link Unified Access System User Manual
VAP 0 is the default network and is the only network enabled by default. In this example,
the Guest networks is on VAP 0, the Corporate Network is on VAP 1, and the L3 Tunnel
Network is on VAP 2.
(switch-prompt) (Config-ap-radio)#vap 2
(switch-prompt) (Config-ap-profile-vap)#enable
9. Associate the L3 Tunnel Network (network 3) with VAP 2.
(switch-prompt) (Config-ap-profile-vap)#network 3
10. Enter CTRL + Z to exit to Privileged EXEC mode and view the network configuration to
make sure the L3 Tunnel Status is listed as “Configured” and to confirm that other
network settings are correct.
(switch-prompt) #show wireless network 3
Network ID..................................... 3
SSID........................................... L3 Tunnel
Default VLAN................................... 1
Hide SSID...................................... Disable
Deny Broadcast................................. Disable
L3 Tunnel Mode................................. Enable
L3 Tunnel Status............................... Configured
L3 Tunnel Subnet IP............................ 192.168.60.0
L3 Tunnel Subnet Mask.......................... 255.255.255.0
Security Mode.................................. WPA Enterprise
MAC Authentication............................. Disable
RADIUS Use AP Profile.......................... Enable
RADIUS Server IP............................... 0.0.0.0
RADIUS Secret Configured....................... No
RADIUS Accounting.............................. Disable
WPA Versions................................... WPA/WPA2
WPA Ciphers.................................... TKIP
WPA Key Type................................... ASCII
WPA Key........................................
WPA2 Pre-Authentication........................ Enable
WPA2 Pre-Authentication Limit (minutes)........ 0
WPA2 Pre-Authentication Timeout (minutes)...... 0
--More-- or (q)uit
WPA2 Key Forwarding............................ Enable
WPA2 Key Caching Holdtime (minutes)............ 10
WEP Authentication Type........................ Open System
WEP Key Type................................... HEX
WEP Key Length (bits).......................... 128
WEP Transfer Key Index......................... 1
WEP Key 1......................................
WEP Key 2......................................
WEP Key 3......................................
WEP Key 4......................................
An important value to note is the L3 Tunnel Status value. The following table lists the
To Next Page
Loading...
Need help?
General
