EasyManuals Logo

D-Link DWS-3024 User Manual

D-Link DWS-3024
270 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #71 background imageLoading...
Page #71 background image
Discovering Access Points and Peer Switches 71
4 Installing the D-Link Unified Access System
6. Click Submit to apply the changes to the switch.
To view information about whether the switch successfully polled the IP address you entered,
click the Monitoring > Global > IP Discovery tab.
The following example shows how to add an address to the L3 Discovery list by using the
CLI.
1. From a Telnet, SSH, or serial connection, log on to the D-Link Unified Switch and enter
the Wireless Configuration mode.
(switch-prompt) >enable
Password:
(switch-prompt) #config
(switch-prompt) (Config)#wireless
2. Add the IP address of a peer switch or AP to the discovery list:
(switch-prompt) (Config-wireless)#discovery ip-list 192.168.6.211
From the CLI, you can only add one IP address at a time.
3. Enter CTRL + Z to return to Privileged EXEC mode.
4. Save the changes to the configuration file:
(switch-prompt) #write
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to save? (y/n) y
Configuration Saved!
To check the managed AP status from the Unified Switch CLI, enter the following command:
(switch-prompt) #show wireless ap status
Setting the Switch IP Address in the D-Link Access Point
You can connect to the D-Link Access Point CLI and statically set the IP address or DNS
name of the D-Link Unified Switch. You can configure up to four D-Link Unified Switches

Table of Contents

Other manuals for D-Link DWS-3024

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the D-Link DWS-3024 and is the answer not in the manual?

D-Link DWS-3024 Specifications

General IconGeneral
BrandD-Link
ModelDWS-3024
CategorySwitch
LanguageEnglish

Related product manuals