EasyManuals Logo

D-Link DWS-3024 User Manual

D-Link DWS-3024
270 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #79 background imageLoading...
Page #79 background image
Authenticating and Validating Access Points 79
4 Installing the D-Link Unified Access System
4. Enter the IP address of the RADIUS server to use for the valid AP database and click
Submit.
Additional fields appear.
5. Configure information that the Unified Switch must use to contact the RADIUS server on
your network, such as the shared secret.
6. Click Submit to apply your changes.
The following example shows how to configure RADIUS authentication by using the CLI:
1. Enter the Wireless Config mode.
(switch-prompt) >enable
Password:
(switch-prompt) #config
(switch-prompt) (Config)#wireless
2. Set the RADIUS server as the validation method.
(switch-prompt) (Config-wireless)#ap validation radius
3. Exit to Global Config Mode and configure the RADIUS settings.
In the following command example, the RADIUS server IP address is 192.168.2.2.
(switch-prompt) (Config-wireless)#exit
(switch-prompt) (Config)#radius server host auth 192.168.2.2
(switch-prompt) (Config)#radius server key auth 192.168.2.2
Enter secret (16 characters max):******************
Re-enter secret:******************
For information about configuring additional RADIUS parameters by using the CLI, see the
D-Link CLI Command Reference.

Table of Contents

Other manuals for D-Link DWS-3024

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the D-Link DWS-3024 and is the answer not in the manual?

D-Link DWS-3024 Specifications

General IconGeneral
BrandD-Link
ModelDWS-3024
CategorySwitch
LanguageEnglish

Related product manuals