Authenticating and Validating Access Points 81
4 Installing the D-Link Unified Access System
NOTE:If you select multiple APs to manage, the Web interface displays the selected
APs in the MAC Address field one by one after you submit a configured AP
entry.
To view the list of failed APs by using the CLI, use the
show wireless ap failure status
command in Privileged EXEC mode. To view the list of APs detected through the RF scan,
use the
show wireless ap rfscan status command.
To add a failed or rogue AP to the local Valid AP database, use the procedures described in
“Using the Local Database for AP Validation” on page 76.
To Next Page
Loading...
