D-Link DXS-3326GSR - Page 227

DXS-3326GSR Stackable Gigabit Layer 3 Switch
config radius
Used to configure the Switch’s RADIUS settings.
config radius <server_index 1-3> {ipaddress <server_ip> | key
<passwd 32> | auth_port <udp_port_number 1-65535> |
acct_port <udp_port_number 1-65535>}
The config radius command is used to configure the Switch’s
RADIUS settings.
<server_index 1-3> − Assigns a number to the current set of
RADIUS server settings. Up to 3 groups of RADIUS server
settings can be entered on the Switch.
ipaddress <server_ip> − The IP address of the RADIUS server.
auth_port <udp_port_number> − The UDP port number for
authentication requests. The default is 1812.
Restrictions
Purpose
Syntax
Description
Parameters
key − Specifies that a password and encryption key will be used
between the Switch and the RADIUS server.

acct_port <udp_port_number> − The UDP port number for
accounting requests. The default is 1813.
<passwd 32> − The shared-secret key used by the
RADIUS server and the Switch. Up to 32 characters can be
used.
Only administrator-level users can issue this command.
Example usage:
To configure the RADIUS settings:
DXS-3326GSR:4#
DXS-3326GSR:4#config radius 1 10.48.74.121 key dlink default
Command: config radius 1 10.48.74.121 key dlink default
Success.
show radius
Purpose Used to display the current RADIUS configurations on the Switch.
Syntax
show radius
Description
The show radius command is used to display the current
RADIUS configurations on the Switch.
Parameters None.
Restrictions None.
219