DXS-3326GSR Stackable Gigabit Layer 3 Switch
----------- --------------- -------- -------- -------------- ------
10.0.0.0 20.0.0.0 10 60 None DOWN
10.1.1.1 20.1.1.1 10 60 None DOWN
Total Entries : 2
OSPF Area Aggregation Settings
Area ID Aggregated LSDB Advertise
Network Address Type
--------------- ------------------ -------- ---------
Total Entries : 0
OSPF Host Route Settings
Host Address Metric Area ID
--------------- ------ ---------------
10.3.3.3 1 10.1.1.1
Total Entries : 1
DXS-3326GSR:4#
create ospf area
Purpose Used to configure OSPF area settings.
Syntax
create ospf area <area_id> type [normal | stub
{stub_summary [enable | disable] | metric <value 0-65535>}]
Description This command is used to create an OSPF area and configure its
settings.
Parameters
<area_id> − The OSPF area ID. The user may enter a 32-bit
number in the form of an IP address (xxx.xxx.xxx.xxx) that
uniquely identifies the OSPF area in the OSPF domain.
type [normal | stub] − The OSPF area mode of operation − stub or
normal.
stub_summary [enable | disable] − Enables or disables the
OSPF area to import summary LSA advertisements.
metric <value 0-65535> − The OSPF area cost between 0 and
65535. 0 denotes that the value will be automatically assigned.
The default setting is 0.
317
To Next Page
Loading...
