DIR-100 Ethernet Broadband Router
PPPoE connection setup menu
To configure a PPPoE Internet connection, follow these steps:
1. Select the PPPoE (Username / Password) option from the My Internet Connection is: pull-down
menu.
2. Choose the IP address assignment option (Dynamic PpoE or Static PPPoE). Static IP address
assignement requires manual entry of IP settings information.
3. Under the PPPoE heading, type the User Name and Password used for your account. A typical
User Name will be in the form
user1234@isp.co.ru. The Password may be assigned to you by your
ISP or you may have selected it when you set up the account with your ISP. Type the password
again in Confirm Password.
4. For Static PPPoE connections, enter IP settings provided by the ISP and, if necessary enter MAC
address (see table below)
5. Leave the MTU value at the default setting (default = 1492) unless you have specific reasons to
change this (see table below for more information).
6. Choose the desired Connection Setting. Select from: Always ON, Connection On Demand, or
Manual. Most users will want to choose the default connection setting, Always ON.
24
To Next Page
Loading...
