MNL-00007 [3] Proprietary and Confidential Page 29 of 63
• It is not possible to enter 60 seconds. You must enter 1:00 minute instead.
• A short beep is sounded for every valid key entered. A long beep is sounded when an
invalid key is entered.
• If power goes off during a treatment, the system will remember how much of the
treatment has elapsed. When power is restored, your device will be on “HOLD”. To
continue the treatment, press START. To cancel the treatment press END.
• The small orange light above the display will be lit when a treatment is in process. It will
blink when the treatment is paused.
20.5 Flex Timer Range and Accuracy
21.0 UV Series X and UV Series T Information
21.1 Domestic and Non-CE Electrical Requirements
Daavlin offers the UV Series Phototherapy equipment in a variety of combinations. Units are
available with lamp quantities of 12, 16, 24, and 28 with various combinations of UVA,
Narrowband UVB, and Broadband UVB. While the type of ultraviolet lamp (UVA or UVB) does
not influence the electrical requirements, the number of lamps contained in a unit does determine
the voltage, amperage, wiring, and outlet necessary to safely support operation. The table and
diagrams below define these requirements for each model variation in the UV Series. Follow
these specifications and all national and local electrical codes when preparing the electrical
supply prior to the installation of a UV Series Device.
Note: This unit should be on a dedicated circuit.
Note: Daavlin UV Series X and UV Series T Phototherapy equipment contain no operator
replaceable parts.
To Next Page
Loading...
Need help?
General
