ENGLISH
38
tE: Display of the temperature of the power stages (°C) 49
bt: Display of the temperature of the electronic card (°C) 49
GS: Display of running status 49
FF: Display of fault history (+ and - to scroll through the alarms) 49
10.
ACCESS TO MANUAL MODE OF THE MACHINE
(SET and + and - keys for 5 seconds)
50
10.1 rt: setting the direction of rotation 50
10.2 Starting the electropump 50
11. GENERAL SYSTEM RESET (MODE and SET and + and – keys) 50
12. RESTORING THE FACTORY SETTINGS (SET and + keys) 50
13. ERROR AND STATUS CONDITIONS 50
13.1 bL: Blockage due to water lack 51
13.2 bP: Blockage due to fault of the pressure sensor 51
13.3 LP: Blockage due to low supply voltage (excluding A.D. M/M 1.1 and A.D. M/T 1.0) 51
13.4
oF/ot :
Blockage due to current overload in the output stages with temperature of the stages
higher than 45°C
52
13.5 SC: Blockage due to direct short circuit between the phases of the output terminal 52
13.6 Manual reset of error conditions 52
13.7 Self-reset of error conditions 52
14. INDICATIONS ON THE DISPLAY 53
INDEX OF TABLES Page
Table 4.
Technical data and limitations of use 39
Table 8.1.
Characteristics and interpretations 42
Table 8.2.
Operation: keyboard factory settings 44
Table 8.6.12
Table summarising the configuration of digital inputs IN1, IN2, IN3 48
Table 8.6.14
Assigning the parameters that associate functions with the digital outputs OUT1, OUT2 49
Table 10.
Access to manual mode of the machine: Use of the keys 50
Table 13.
Error and status conditions: Warnings in the fault log 51
Error and status conditions: Error conditions 51
Table 13.7.
Automatic resets of error conditions 52
Table 14.
Indications on the display 53
INDEX OF FIGURES page
Fig. 1
Logic-functional diagram of the connections of the alarm output terminals 42
Fig. 2
Connection diagram for 2 ACTIVE DRIVERS for exchange function 42
Fig. 3
Logic-functional diagram of the connections of the user input terminals 43
To Next Page
Loading...
Need help?
General
