If the decimal point is changed after presetting, displaying value does not increase
according to the decimal point.
Press Function key and then Up key to become
->
Press ENT key to choose decimal point setting.
Press Shift key to choose the required number.
Press ENT key to store the number.
-> -> (In case it is not good, will come out.)
If you want to get out of the setting mode and return to the measurement mode,
you may have to push the Function key.
(Currently the value is indicated.)
6-4. Setting Round off
It is to set the variations of display number. When the value varies considerably, you
can set it properly. It is possible to set 1, 2, 5, 10, 20, 50, 100.
Press Function key and then Up key to be
->
Press ENT key to choose round off setting.
Press Shift key to choose the required number.
Press ENT key to store the number.
-> -> (In case it is not good, will come out.)
If you want to get out of the setting mode and return to the measurement mode,
you may have to push the Function key.
(Currently the value is indicated.)
6-5. Setting Peak Hold, Sample Hold
This Product also has Peak Hold Function. So if you need this function, you can use
this, with operating as follows. When you are in this mode. You can reset the value by
pressing key.
Press Function key and then Up key to be
9
->
To Next Page
Loading...
Need help?
General
