Press ENT key to choose Hold setting.
Press Up key to choose Peak Hold or Sample Hold setting.
Press ENT key to store it.
-> -> (In case it is not good, will come out.)
If you want to get out of the setting mode and return to the measurement mode,
you may have to push the Function key.
6-6. Setting Baud Rate
This mode is designed to set up Baud Rate when you engage in serial
communication.
You can set up 2400, 4800, 9600, 19200 bps.
Press Function key and then Up key to be
->
Press ENT key to choose baud rate setting.
Press Shift key to choose what you want.
Press ENT key to store it.
-> -> (In case it is not good, will come out.)
If you want to get out of the setting mode and return to the measurement mode,
you may have to push the Function key.
(Currently the value is indicated.)
6-7. Setting ID Number
In RS485 or RS232C Command mode, it is used for giving product specific number.
Press Function key and then Up key to be
->
Press ENT key to choose ID number setting.
Press Up key to change the required number.
(When it presses Up key, the number increases. When it presses Shift key, the
number decrease)
…….
Press ENT key to store it.
10
-> -> (In case it is not good, will come out.)
To Next Page
Loading...
Need help?
General
