dacell DN-10 - Setting Auto Tracking Time; Calibration; Real-weight Calibration

If you want to get out of the setting mode and return to the measurement mode,
you may have to push the Function key.
(Currently the value is indicated.)
6-12. Setting Auto Tracking Time
As setting time to operate Auto zero, it set up 0.1~5.0 second.
According to 6-1, Press Function key and then Up key to be
.
->
Press ENT key to choose time mode.
Press Up key to change the required number.
…….
Press ENT key to store it.
-> -> (In case it is not good, will come out.)
If you want to get out of the setting mode and return to the measurement mode,
you may have to push the Function key.
(Currently the value is indicated.)
Ex) After setting Zero Tracking range
and Auto Tracking time , when do
not change input signal, and then, Display is or , after 0.2 second,
Display is .
13