Press Up key to be
Press ENT key, It uses Shift key and Up Key and it inputs Sensor output
value.
Press ENT key to store it.
-> -> (In case it is not good, will come out.)
If you want to get out of the setting mode and return to the measurement mode,
you may have to push the Function key.
(Currently the value is indicated.)
8. Setting KEY LOCK
This can be used as two function.
If you choose , Span Calibration does not operate.
If you choose , Span Calibration is possible.
Press Function key and Power on.
Select
After selecting or , press ENT key to store it.
If you choose -> Setting is impossible. You only use hi, low and zero key.
If you choose -> Setting is possible.
16
To Next Page
Loading...
Need help?
General
